Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Driveway & Pavers for Burbank Homeowners
A driveway in Burbank takes a beating that most of the country never sees. The sun bakes the surface from May through October, winter rain comes in short hard bursts that run off the Verdugo foothills, and roots from old ficus and jacaranda trees push up from below. When the slab starts cracking or the pavers shift, water finds the gaps and the problem gets worse every rainy season. That’s the call we get most.

We install and replace paver, concrete, and asphalt driveways, plus patios, walkways, and pool decks, using material from Belgard, Unilock, and Tremron. Our technicians have up to 15 years of experience, and we can usually schedule an on-site look at your driveway in Burbank quickly. Call (833) 954-6131 to set up a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Driveway & Pavers Service Includes
Every surface on a property works differently under Burbank’s sun and soil. We treat each one on its own terms, from a full driveway build to a small sealing job.
Paver Driveways
Paver driveways are set stone by stone over a compacted base, which is why they flex with ground movement instead of cracking the way a rigid slab can. They make sense when you want a surface that can be lifted and reset if a section settles, and when curb appeal matters on a Burbank street where driveways are visible from the sidewalk. We work with Belgard, Unilock, and Tremron systems and lay out the pattern, border, and color mix with you before anything goes down.
Concrete Driveways & Concrete Work
Concrete is the straightforward choice when you want a clean, uniform surface and a lower upfront number. It’s the right call for a fresh pour or a replacement where the old slab has failed at the joints. We handle the form work, reinforcement, and finish, using Sakrete mixes for patching and repair work where a full pour isn’t needed, and we talk through joint spacing so the slab has room to move in the heat.
Asphalt Driveways & Resurfacing
Asphalt gives you a smooth, quiet surface and often the lowest cost per square foot of the three main options. It’s a good fit for longer driveways or when budget is the deciding factor. Resurfacing an asphalt driveway that’s worn but structurally sound can extend its life, and we’ll tell you honestly when a surface layer will hold and when the base underneath needs rebuilding first.
Driveway Repair & Replacement
Not every cracked driveway needs to come out. Sometimes a section repair, a re-leveled paver field, or fresh sealer solves the problem. Replacement makes sense when the base has failed, when cracks keep returning after patching, or when the slope no longer drains water away from the house. We assess the base, not just the surface, because that’s what determines whether a repair will last.
Patios, Walkways & Pool Decks
The same materials that hold up in a driveway work around the back of the house. Patios, paths, and pool decks in Burbank face constant sun and, near a pool, standing water and chlorine splash. We build paver patios and walkways with proper slope and drainage so water moves away from the house and the surface stays stable through summer heat. Ask about texture and finish choices that stay cooler and grippier underfoot.
Brick Paver Driveway
Brick pavers bring a warmer look than gray concrete and hold color well under UV. They suit older Burbank homes where a period-appropriate driveway fits the architecture. We set brick in the pattern and bond you choose, over a properly compacted base, so the joints stay tight and the surface stays level.
Stamped Concrete Driveway
Stamped concrete gives you the look of stone or brick at a lower material cost than real pavers. It’s a fit when you want pattern and color without the individual-unit installation. We pour, stamp, and seal it, and we’re upfront that stamped concrete needs resealing to hold its color, so you go in knowing the upkeep.
Driveway Sealing
Sealing protects the surface from sun fading, water intrusion, and stains, and it’s the cheapest way to extend the life of a driveway you already have. It’s worth doing on asphalt every few years and on stamped concrete to keep the color. We clean and prep the surface first, because sealer over dirt or cracks just traps the problem.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Driveway & Pavers
Belgard makes a wide range of paver styles and systems, and we know how their different product lines handle the sun and soil here. Their interlocking systems and retaining wall products come up often on Burbank properties with sloped front yards, and we plan the base and edge restraint around the specific line you pick. Unilock pavers are dense and hold their color, and we’ve learned which of their finishes stay coolest underfoot on west-facing driveways that take the afternoon sun.
Tremron is a strong choice when you want a proven paver at a sensible price point, and we plan joint spacing and base depth around their tolerances so the surface stays true. Sakrete mixes are our go-to for concrete repair and patching where matching an existing surface matters. Whether you have Belgard, Unilock, Tremron, or any other make, we can help.

Signs You Need Driveway & Pavers Right Now
- Cracks that keep coming back. If you’ve patched the same crack more than once, the problem is under the slab, not on top of it. Water is getting into the base, and the fix is usually deeper than another tube of filler.
- Pavers that rock or sink. A paver that moves when you step on it has lost its base support. Left alone, the movement spreads to the surrounding stones and the joints open up to rain and weeds.
- Ponding water after rain. Water that sits in the same spot after every storm is a drainage and slope problem. It can work its way under the driveway and toward the foundation, so it’s worth addressing before the next wet season.
- Sunken or uneven sections. A dip at the garage apron or a dip mid-driveway can catch a tire and trip a foot. Uneven ground usually means the base has settled and needs re-leveling or partial rebuild.
- Faded, chalky concrete with exposed aggregate. When the surface paste wears away and the stones show through, the slab is losing its top layer to sun and wear. Sealing at that stage slows the decline; waiting usually means replacement sooner.
Our Driveway & Pavers Process – Step by Step
- 1
On-site look and measurements. We walk the property, measure the square footage, check the slope and drainage, and look at what’s under the existing surface where we can see it. This is a free estimate, and we give you a written line-item quote so you know what each part of the job costs.
- 2
Material and layout selection. We sit down with the Belgard, Unilock, or Tremron samples and the concrete and asphalt options, and go through pattern, color, border, and finish. You pick a material that fits the house and the budget, not the one that happens to be on hand.
- 3
Site prep and base work. This is the part nobody sees and the part that decides whether the driveway lasts. We excavate to the right depth, compact the base in layers, and set drainage and edge restraint so the surface stays put through hot summers and rainy winters.
- 4
Installation. Pavers get laid to the chosen pattern and cut clean at the edges. Concrete gets formed, reinforced, poured, and finished with proper joints. Asphalt gets graded and compacted or resurfaced over a prepared base. We keep the site tidy and protect the rest of the property while we work.
- 5
Final walk-through and care notes. We walk the finished surface with you, check the slope and drainage, and go over sealing timelines and how to keep the surface looking right. Any permit the job requires is pulled before we start, and we handle the inspection.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Driveway & Pavers Cost in Burbank?
Driveway work in Burbank is priced by the square foot, the material, and the condition of the base, not by a flat number. Here are typical estimated ranges for the most common jobs:
| Service | Typical Estimated Range |
|---|---|
| Paver driveway installation | $7000 – $18000 |
| Concrete driveway installation | $4500 – $12000 |
| Asphalt driveway paving | $3500 – $9000 |
| Driveway replacement | $5000 – $14000 |
| Paver patio installation | $3500 – $11000 |
| Driveway sealing | $250 – $700 |
A typical paver driveway in Burbank runs $7000 – $18000 depending on square footage, paver line, pattern complexity, and how much old surface has to come out. A concrete driveway installation lands in the $4500 – $12000 range, with stamped finishes and thicker pours at the higher end. Asphalt paving usually comes in between $3500 and $9000.
What moves the number most is the base. A driveway over failed soil or old tree roots costs more to rebuild than a straight replacement over solid ground. Slope and drainage corrections, edge restraint, and the amount of demolition add to it too. To avoid overpaying, get a written line-item estimate that separates base work from surface work, so you can see what you’re paying for and compare like for like. Our free estimate includes measurements, material options with pricing, and a written quote, and the written estimate sets the final price.
Driveway & Pavers Near Burbank – Our Service Area
We work on driveways and hardscape throughout Burbank and the surrounding area, including San Fernando, Los Angeles, West Hollywood, Beverly Hills, and Culver City. Whether your project is a full driveway replacement or a patio and walkway refresh, we’ll schedule an on-site look and give you a written estimate. See our driveway & pavers work for a closer look at the options, and explore the full range of Construction Burbank services if your project extends to fencing, windows, or a home addition.
Serving Burbank, CA – Our Local Coverage Area
We serve Burbank and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Driveway & Pavers in Burbank
It’s the design, installation, repair, and sealing of hard outdoor surfaces, including paver, concrete, and asphalt driveways, plus patios, walkways, and pool decks. We handle everything from a single section repair to a full driveway replacement with new base and drainage. Every job starts with an on-site look and a written line-item estimate so you know the scope before work begins. Call (833) 954-6131 to schedule yours.
A typical concrete driveway takes a few days from prep to finish, while a paver driveway usually runs longer because each unit is set by hand. Sealing and small repairs can often be done in a single visit. The base condition, square footage, and drying or curing time all affect the schedule. We give you a realistic timeline in the written estimate. Call (833) 954-6131 for an exact quote.
Typical estimated ranges run from $3500 – $9000 for asphalt paving, $4500 – $12000 for concrete installation, and $7000 – $18000 for a paver driveway, with sealing between $250 and $700. Replacement usually falls between $5000 and $14000 depending on what has to come out. The base, square footage, and material choice drive the final number. The written estimate sets the final price, and estimates are free. Call (833) 954-6131 for an exact quote.
Yes. We install Belgard, Unilock, and Tremron paver systems and can walk you through the pattern, color, and finish options for each. We plan the base depth and edge restraint around the specific product line so the surface holds up in Burbank’s heat and rain. If you’ve already picked a paver, bring the sample or the name and we’ll work from it. Call (833) 954-6131 to talk through your options.
We can often schedule an on-site look quickly, and same-day service is possible for smaller repairs and estimates. We answer 24/7 for phone calls, with fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours is booked into the next opening. Call (833) 954-6131 to get on the schedule.
Coverage depends on the material and the manufacturer’s program, so we spell it out in your written estimate rather than making a blanket promise. Paver manufacturers and concrete and asphalt suppliers each set their own terms, and we go over what applies to your job before you sign. You’ll know exactly what’s covered. Call (833) 954-6131 for the details on your specific project.
Clear the driveway and the work area of cars, bins, and anything stored outside before we arrive, and let us know about irrigation lines, gas or water shutoffs, or utilities near the work zone. If you have an HOA or a planned inspection, mention it up front so we can plan the permit and inspection steps. We’ll confirm the schedule and access details the day before. Call (833) 954-6131 with any questions before the crew arrives.
Schedule Your Driveway & Pavers Service in Burbank Today
Whether it’s a new paver driveway, a concrete replacement, or a patio and walkway that finally ties the yard together, we can give you a written estimate and a material plan that fits the property. Our technicians have up to 15 years of experience, and estimates are free with no obligation. Call (833) 954-6131 to schedule yours. We answer 24/7.
Written by the team at Construction Burbank.